Student Radiation Monitor (SRM-BTD, discontinued)
Specifications and User Guide

This product is no longer available.

TROUBLESHOOTING
-Primary Test: Is the 9 V battery good? Are the correct settings chosen on the sensor?
-Primary Test: Are the monitor and source positioned properly for the type of radiation to be detected? Note that this monitor does not read alpha radiation. When monitoring weaker radiation, the transparent window on the back of the detector should be oriented toward the source of radiation.
-Secondary Test: Some types of radiation are very difficult or impossible for this GM tube to detect. Beta emissions from tritium are too weak to detect using the Radiation Monitor. Americium-241, used in some smoke detectors, can overexcite the GM tube and give an indication of a higher level of radiation than is actually there.

RELATED TIL ENTRIES
Where can I buy sources for nuclear radiation activities?
Can I use the Pasco Radiation Monitor with a Vernier interface?
What are the output signals of the Radiation Monitors?
Can I monitor the radioactivity of red Fiestaware with your Radiation Monitor?
When I plug the radiation monitor into LabPro it stops working. (especially if you have been using DCU).




Can the Geiger tube in my Student Radiation Monitor be repaired?

SPECIFICATIONS
-new order code: SRM-BTD
-old order code: SRM-DG (ULI only)
-Sensor: Halogen quenched glass Geiger-Mueller (GM) tube. The wall density of the GM tube is 50 mg/cm2
-Power: One 9-volt alkaline battery provides a battery life of 500 hours. Low battery condition is indicated when count light is dimmed.
-Sound: An audio beeper indicates radiation events. This feature can be muted
-Visual: The red LED count light indicates radiation events.
-Dimensions: 30 X 80 X 150 mm (1.2 X 3.2 X 5.9 in)
-Weight: 200 g (7 oz) with battery installed
-Sensor output and cable pinouts are available on www.vernier.com.
-Audio Output: The 2.5 mm mono jack produces 8-volt AC coupled output suitable for amplifier input, tape recorder input, or RS232-compatible interface to personal computers

CALIBRATION
It is not necessary to calibrate this sensor.

RELATED VERNIER PRODUCTS
–Radiation Monitor (RM-BTD, discontinued)