Specifications and User Guide TROUBLESHOOTINGPrimary Test: Are the leads properly and securely connected? The probe is designed to be used like voltmeter leads. It should......
Experiments that are written for the or the can be performed with standalone voltage and current probes, but you will need to set up the......
You can use the standard , to do Ohm’s Law experiments. There are two things you need to watch out for, and for these reasons......
The output of the Vernier , is bipolar. The negative terminal is not quite at ground, because of the presence of a small current sense......
Special caution should be taken when operating at greater than ±20 volts in a situation where significant current can be supplied. Many solar panel projects......
The key difference is that the black leads on the simple Voltage Probe (VP-BTA) are connected to ground of the interface when used. That means......
It is always a bit tricky to state an accuracy figure, since it depends on what the sensor is connected to and how it has......
In the DCP and DVP manuals, we specify that the maximum voltage on any input is +/-10V. This is our stated over voltage protection (our......