Posts tagged with: LED

The is a great starter set of output devices for use with the . The kit includes several output devices, including a motor, LEDs, incandescent......
Continue Reading →
The can be used with any DC electronic component or output device that requires only power and ground connections, such as an LED, buzzer, or......
Continue Reading →
No. The 10 mm LEDs sold with the are not resistor protected. LEDs typically need a resistor to prevent damage from current that is too......
Continue Reading →
The LED on the Go!Temp, Go!Motion, Go!Link, LabQuest Mini, or LabQuest Stream is a useful troubleshooting tool: LED Color Device Status Solution Green Receiving power......
Continue Reading →
Yes, you can. Please call our office and ask to speak with a chemist or email chemistry@vernier.com with your required wavelength and contact information. Custom......
Continue Reading →
The power button for the Light and Color Sensor also turns on the white LED. In order to turn on the light, turn the sensor......
Continue Reading →
There are two LED types included with the , a 10 mm red diffused LED and a 5 mm bi-color LED that appears white when......
Continue Reading →
This article specifically refers to the use of the and with the . If you suspect your generator does not work and you are not......
Continue Reading →
The calibration button on the CO2 Gas Sensor can become stuck in the depressed position by being caught under the edge of the plastic. If......
Continue Reading →