Specifications and User Guide TROUBLESHOOTING -Primary Test: Connect the Radiation Monitor to an interface and launch the software (either the LabQuest App or Logger Pro......
Similarities Detect the presence of a source of radiation Monitor counts/interval (rate) as different thicknesses of a particular type of shielding are placed between the......
Radioactive sources are available from a number of suppliers. We recommend Spectrum Techniques highly. Spectrum Techniques 106 Union Valley Road Oak Ridge, TN 37830 (865)......
The Vernier light sensors can not be used to measure PAR, photosynthetically active radiation. They do not have the right spectral response nor are they......
The first experiment in our book is all about this subject. Details and the table of contents can be found at https://www.vernier.com/nrv The following is......
The meter on the sensor reports count rate in various units such as counts per second, but our software reports total counts during each time......
The , is supported by the TI-Nspire Lab Cradle, but only if the correct cable is used. Until June 2011, DRMs were shipped with a......
On both radiation monitors we use a 2.2k pull up resistor in our cables to get a 5-volt signal that goes low for each event.......
Absolutely. Red Fiestaware prior to 1972 used uranium oxide, U3O8, in the glaze as a colorant. The color was dropped in 1943 when all uranium......
If you find that the radiation monitor works normally, but quits working when you start using a DCU (Digital Control Unit), it is because the......