To get the most accurate readings from the Voltage Probe, when measuring the half cell potential in a chemistry experiment (such as Lab 28 from......
If you calibrate a PH-BNC electrode with an Electrode Amplifier (EA-BTA), typical potential readings are -pH 4 buffer solution: 1.56 volts -pH 7 buffer solution:......
Electrical power is the product of Potential (Voltage) and Current. Readings may fluctuate because the wind coming out of the fan is fluctuating. This can......
Due to the simple nature of the sensor, the ±10 V may not read 0 V when the leads of the sensor are not connected......
The following PDF document shows how to use a multimeter to measure current or voltage in a KidWind setup. Two multimeters are needed to measure......
You can use the standard , to do Ohm’s Law experiments. There are two things you need to watch out for, and for these reasons......
Special caution should be taken when operating at greater than ±20 volts in a situation where significant current can be supplied. Many solar panel projects......
You likely are not producing enough voltage with your turbine design. The color of an LED determines the minimum voltage needed for it to emit......
The SensorDAQ voltage probes only give a meaningful reading when they are connected to something. When the leads are not connected to anything, ignore the......
For Go Direct ISEs (order codes begin with GDX-), simply enable the sensor’s mV channel in the app. For most LabQuest ISEs (order codes end......