My Go Direct Temperature is stuck at 0 degCMarch 16, 20210 There could be a couple of issues that result in this symptom:1) A firmware update is needed. See 2) Reset the probe by pressing and...... Continue Reading →
Ethanol Sensor never reads zero.November 16, 20180 All Vernier ethanol sensors will never give a reading of 0 in air because of the type of calibration formula that is used. The minimum...... Continue Reading →
When I hold the tip of the Go Direct 3-Axis Magnetic Field sensor next to the pole of a magnet, the sensor reads zeroMay 9, 20170 This article refers to the For information about the , see The Go Direct 3-Axis Magnetic Field Sensor has two ranges. The high-precision range is...... Continue Reading →
Why does the 10 V voltage probe not read zero when the clips are disconnected?April 28, 20170 Due to the simple nature of the sensor, the ±10 V may not read 0 V when the leads of the sensor are not connected...... Continue Reading →
Motion Encoder does not maintain its zero point between runs.January 17, 20170 This issue occurs when using a , with a LabPro Interface. The zero point is not maintained between experimental runs. This is caused by an...... Continue Reading →
How do I get the Goniometer to report both positive and negative joint angles?January 3, 20130 If you are interested in measuring flexion and extension of a joint, you can zero the to report both positive and negative joint angles from...... Continue Reading →
Logger Pro 3 dynamic range is 1.1e-99 to 1e99.April 16, 20100 Recent versions of Logger Pro (3.5 and newer) allow a dynamic numeric range of 1.1e-99 to 1e99. Older versions have more limited range. If a...... Continue Reading →