Did you mean "Go Direct Regular; Glass-Body pH BNC Electrode"

1. • The glass bulb of my pH Sensor is broken. Can it be repaired?
   • No, unfortunately a broken glass bulb on any of our pH sensors cannot be repaired or replaced and is not covered by the warranty. We...
   • https://www.vernier.com/til/782/
2. • Which model pH sensor do I have? (How old is my pH sensor?)
   • Vernier sells three different categories of pH sensor depending on the type of pH electrode used: standard, tris-compatible flat pH, and glass-body pH. Use the...
   • https://www.vernier.com/til/4110/
3. • The pH electrode I have been using no longer seems to work or is slow to respond. Is there anything I can do to fix it?
   • When testing a pH Sensor (, , ), it is best to place it into a known buffer solution. This allows you to see if...
   • https://www.vernier.com/til/730/
4. • Glass-Body pH Electrode BNC: Troubleshooting and FAQs
   • Proper Set-Up * Electrode Amplifier is required but not included: , , or Go Wireless Electrode Amplifier (GW-EA, discontinued). Troubleshooting Additional Troubleshooting OPERATION CALIBRATION MAINTENANCE...
   • https://www.vernier.com/til/3793/
5. • Data Collection with Go Wireless pH/Electrode Amplifier FAQs
   • Data Collection with Go Wireless pH/Electrode Amplifier FAQs Q: What are the steps to start data collection with a Go Wireless pH? A: Follow the...
   • https://www.vernier.com/til/3375/
6. • What is the best way to clean the glass bulb of the pH electrode?
   • Generally, rinsing the electrode with distilled water after using should suffice. If the glass bulb looks dirty, you can rinse the electrode with warm water...
   • https://www.vernier.com/til/706/
7. • What type of liquids cause problems for the pH Sensor?
   • There are two issues here: 1) Solutions that are difficult to measure 2) Solutions that will damage the sensor Solutions that are Difficult to Measure...
   • https://www.vernier.com/til/1599/
8. • Go Wireless pH and Go Wireless Electrode Amplifier Troubleshooting and FAQs
   • These products are no longer available. Information is presented for reference only. Go Wireless® pH (GW-PH), discontinued Go Wireless® Electrode Amplifier (GW-EA), discontinued Hardware &...
   • https://www.vernier.com/til/3272/
9. • During calibration, what are the typical potential output readings for the PH-BNC electrode?
   • If you calibrate a PH-BNC electrode with an Electrode Amplifier (EA-BTA), typical potential readings are -pH 4 buffer solution: 1.56 volts -pH 7 buffer solution:...
   • https://www.vernier.com/til/3641/
10. • How can I keep my pH or ORP storage solution from spilling when the sensor is in use?
    • After removing the sensor but before screwing the cap back on the storage solution bottle, place a nickel under the cap and screw the cap...
    • https://www.vernier.com/til/728/