Go Direct® Conductivity Probe (GDX-CON)
Specifications and User Guide

TROUBLESHOOTING
-Primary Test: Take a reading in a solution of known value. A reading close to that value should register.

RELATED TIL ENTRIES
Where do I get Conductivity Standards?
What material are your Conductivity Probes made of?

What chemicals can I use with your conductivity probes?

Why can I only perform a one-point calibration with my Go Direct Conductivity sensor?
What is the difference between salinity and conductivity?

CALIBRATION
-You do not have to perform a new calibration when using the Conductivity Probe for most experiments in the classroom. However, if your experimental application requires more accurate readings, you should calibrate your sensor.
-See How do I calibrate my sensor? for calibration instructions
Why can I only perform a one-point calibration with my Go Direct Conductivity sensor?

BATTERY TROUBLESHOOTING
If the sensor can be turned on when connected by USB but not when disconnected from USB, the battery either needs charging or has reached its end of life and can no longer hold a charge. First, try charging the sensor for several hours. If the sensor still won’t turn on when disconnected from USB, the battery has likely reached its end of life. If you intend to use this sensor wirelessly, the battery will need to be replaced. The rechargeable battery in this sensor is covered by a one year warranty but should last two to five years in typical use.
How do I replace the battery in a Go Direct Wand-Type Sensor?

RELATED VERNIER PRODUCTS
-Conductivity standard solution, low range, Conductivity Standard Solution (CON-LST) (500 mL)
-Conductivity standard solution, mid range, Conductivity Standard Solution (CON-MST) (500 mL)
-Conductivity standard solution, high range, Conductivity Standard Solution (CON-HST) (500 mL)