Go Direct® Motion Detector (GDX-MD) Specifications and User Guide Which Motion Detector model do I have? Troubleshooting Press the power button on the sensor to turn it on. Connect your sensor as described in the Getting ...

Generally, calibrations are not required; therefore, most motion detectors don't support calibration. Calibrate a Go Direct Motion Detector Only the Go Direct Motion Detector can be calibrated. A one-point calibration, based on a measured d...

The answer depends on the motion detector you have. This type of damage is not covered under warranty. Can Be Repaired The transducer on a Go Direct Motion Detector can be replaced in the event of damage. However, there will be a repair fee. C...

The information below is relevant if using specific Vernier interfaces (LabPro, original LabQuest, LabQuest Mini, and LabQuest Stream) connected to a Windows computer running Logger Pro (3.14.1 or newer) or Logger Lite (v1.9.3 or newer). Important n...

If the LabQuest 2 screen is a solid white, please try the following: 1. Try to turn the unit off by holding the power button down for 10 seconds.     If the unit won't shut off that way:     a. Re...

Windows 7 Operating Systems, which are significantly behind in Windows Updates, may experience problems in installing and finalizing the device driver for Go Direct® SpectroVis® Plus Spectrophotometer (GDX-SVISPL), after installation of Logge...

Optics Expansion Kit (OEK) Specifications and User Guide Center thickness of the three lenses included in the Optics Expansion Kit: 10 cm convex – 8.3mm 20 cm convex – 5.0mm 15 cm concave – 1.7mm What has changed in the revised Optics Expansion...

Locating the serial number will depend on the version of the spectrometer. Vernier Technical Support may be able to use the serial number located on the spectrometer to determine the approximate age of the device. SpectroVis Plus (SVIS-PL, discon...

This can happen when Logger Pro, LabQuest App or Spectral Analysis can't tell the difference between the dark and light sample during calibration. If you are using a standard, water blank (nothing opaque), then the light source is probably not operat...

Vernier sensors can be used as inputs to National Instruments' NI LabVIEW software. The essential components necessary to use our sensors with LabVIEW are: 1. Vernier interface or adapter, such as: *SensorDAQ (SDAQ). This Vernier interface was desig...