pH Sensor (PH-BTA)
Specifications and User Guide
Which model pH sensor do I have? (How old is my pH sensor?)
Troubleshooting
Primary Test: Does it read approximately 4 in its storage solution? Note: A reading of 13 to 14...
We can often replace cracked screens on LabQuest 2 and LabQuest 3 units at this time. Unfortunately, we no longer have access to screens for the original LabQuest.
Screens damaged during use are not covered under our warranty. If you would lik...
Go Direct Acceleration
Go Direct® Acceleration Sensor (GDX-ACC)
This is our most versatile accelerometer. It has two ranges (±16 g and ±200 g), measures three axes of acceleration, and has a built in three-axis gyroscope and an altim...
The MakeBlock and mBlock apps, on both iOS and Android, connect to mBot via Bluetooth wireless technology.
Verify mBot is turned on.
Verify that the Bluetooth radio has been installed on mBot.
Verify that mBot is NOT already connected to anoth...
If you have connected your mBot to your PC/Mac/Chromebook via USB and you cannot get the mBlock software to connect to your mBot, try the following:
1. Verify that mBot is turned on.
2. Verify that the Arduino driver is installed.
The microcontrol...
mBlock, one of the iOS programs for use with mBot and other MakeBlock robots requires iOS 9 or newer.
mBot Troubleshooting and FAQs...
If you are selectively enabling Bonjour on your network (via Bonjour Gateway or another such method) then you will need to allow LabQuest Bonjour service strings. They are:
_vernier-data._tcp.
_labquest-rfb._tcp.
Note: Depending on your network conf...
This is an error that results from the LabVIEW installer attempting to install the LabQuest driver. The LabQuest USB driver that was included with this installer is no longer valid on Windows computers. When you run the installer you will get a serie...
Yes, Vernier sensors can be used with the NI-ELVIS system.
To connect Vernier analog sensors to NI-ELVIS use the Analog Protoboard Adapter (BTA-ELV)
To connect Vernier digital sensors to NI-ELVIS use the Digital Protoboard Adapter (BTD-ELV)
...
Yes. We have developed an adapter that makes it easy to connect Vernier LabQuest sensors to the NI myDAQ.
Please be aware that this adapter can only be used with sensors that have a BTA cable. They cannot be used with Go Direct Sensors.
Vernier...