The most common error that occurs with the LabVIEW examples for LabQuest is a problem with the driver and/or the DLL file to communicate with the driver.
At the heart of the LabVIEW examples for LabQuest are subVIs that use LabVIEW's Call Library Fu...
Yes. The Vernier myDAQ Adapter is designed to connect with the NI myRIO, as well as the NI myDAQ.
Vernier myDAQ Adapter (BT-MDAQ)
Both the myDAQ and myRIO have the same 20-position screw terminal with the exact same input/output pins. Therefore...
This information pertains to the original LabQuest.
If you have LabQuest 2, see this article.
To prepare a USB thumb drive for updating LabQuest, do the following:
1. Start with a clean and validated USB drive. See My USB drive is not recognized...
pH Sensor (PH-BTA)
Specifications and User Guide
Which model pH sensor do I have? (How old is my pH sensor?)
Troubleshooting
Primary Test: Does it read approximately 4 in its storage solution? Note: A reading of 13 to 14...
We can often replace cracked screens on LabQuest 2 and LabQuest 3 units at this time. Unfortunately, we no longer have access to screens for the original LabQuest.
Screens damaged during use are not covered under our warranty. If you would lik...
Go Direct Acceleration
Go Direct® Acceleration Sensor (GDX-ACC)
This is our most versatile accelerometer. It has two ranges (±16 g and ±200 g), measures three axes of acceleration, and has a built in three-axis gyroscope and an altim...
The MakeBlock and mBlock apps, on both iOS and Android, connect to mBot via Bluetooth wireless technology.
Verify mBot is turned on.
Verify that the Bluetooth radio has been installed on mBot.
Verify that mBot is NOT already connected to anoth...
If you have connected your mBot to your PC/Mac/Chromebook via USB and you cannot get the mBlock software to connect to your mBot, try the following:
1. Verify that mBot is turned on.
2. Verify that the Arduino driver is installed.
The microcontrol...
mBlock, one of the iOS programs for use with mBot and other MakeBlock robots requires iOS 9 or newer.
mBot Troubleshooting and FAQs...
If you are selectively enabling Bonjour on your network (via Bonjour Gateway or another such method) then you will need to allow LabQuest Bonjour service strings. They are:
_vernier-data._tcp.
_labquest-rfb._tcp.
Note: Depending on your network conf...