The Rotary Motion Accessory Kit works with the and the . Everything in the will work with the older sensors with one important exception. To......
There are two resolutions for our Rotary Motion Sensors. Low resolution and High resolution which leads to 4 times as many pulses for a given......
Specifications and User Guide Troubleshooting Note: If you are using a LabPro interface, open the Rotary Motion Angular.cmbl file from the Probes and Sensors folder......
The dimensions and masses are the same for the Standard Rotary Motion Sensor and the Go Direct Rotary Motion Sensor. The measurements are as follows:......
This information pertains to the original LabQuest. If you have LabQuest 2, see this article. This document has information for device drivers that work with......
Specifications and User Guide Troubleshooting Important: This sensor is for use in air and water only. For temperature measurements in harsher environments, we recommend the......
Specifications and User Guide TROUBLESHOOTING -Primary Test: Plug in the sensor and start up the data-collection program. Temperature readings should appear on the main screen......
Specifications and User Guide TROUBLESHOOTING -Primary Test: Connect the Colorimeter. Allow the Colorimeter to warm up for 5 minutes. Place a cuvette, about 3/4 full......
Unfortunately, the tab on the connector can not be replaced, and it is not a simple matter to clip off the end of the cable......
When LabQuest 2 starts up, it should automatically launch a screen with menus for “File Sensors” across the top. If it turns on and loads......