PGC Scientific in Gaithersburg, Maryland, about $130 per dozen. The 10-mL syringe with the Luer Lock connector.
Aldrich Chemical also sells the "Perfectum" syringes, which were used in the February 2006 Americal Journal of Physics article....
Placing your specimen slide on top of a small fluorescent lamp will provide even, cool back-lighting. A light table used for slides works well. Overhead projectors, generally used for transparencies, can also be used. Place a piece of white paper o...
- Always quit the data collection program gracefully before removing the LabPro from the computer or calculator. When the program quits, it turns LabPro off. If you do not do this and you just disconnect the cords and put the LabPro away, it will st...
During data collection, it is possible that EasyData App will quit if the battery level in the calculator gets too low. The power required to collect data with an EasyTemp or EasyLink is greater than that needed for normal operation of the calcula...
The CBR 2 can work with the TI-89 Titanium through the I/O port of the CBR 2. It does not work through the USB port on the calculator. For a calculator program, you will need the Ranger program accessed using the link below.
...
This information pertains to the original CBL only. There are two scenarios here. Both apply equally to ChemBio, Physics and PhySci programs.
Sensor Supported in the Program
If your auto-ID sensor is of a type already supported in the prog...
CBR 2
Original CBR
These features are in common
Both are motion detectors made by Texas Instruments that can connect directly to TI calculators
Both require 4 AA batteries when used with TI calculators
Both have a I/O (dBus...
1. Perform a soft-reset on the handheld and try HotSync again. Sometimes this is caused by running Data Pro while connected to the HotSync cradle/cable. This interferes with any subsequent attempts at the HotSync process until you have performed a so...
In the Spring of 1997, Knowledge Revolution began bundling our Serial Box Interface and a few of our sensors with their e-Probe software and selling it directly through Apple. As of September of 1999, eMate is no longer sold and Knowledge Revolution ...
The Data Pro conduit was unable to find on the Palm a valid database file that is used to upload data to the computer. To fix this, run Data Pro on the Palm device to recreate the database file, exit Data Pro, and retry the HotSync operation....