When testing a pH Sensor (pH Sensor (PH-BTA), Tris-Compatible Flat pH Sensor (FPH-BTA), Go Direct® pH Sensor (GDX-PH)), it is best to place it into a known buffer solution. This allows you to see if the sensor is reading correctly (e.g., in a bu...
You can attach the Wireless Dynamics Sensor System (WDSS) to the beam of the Go Direct® Centripetal Force System (GDX-CFA). This will allow you to collect force and acceleration data.
We recommend using the Go Direct® Force and Accelerati...
You may want to use a photogate (either Go Direct® Photogate (GDX-VPG) or Photogate (VPG-BTD)) to measure angular velocity of the Go Direct® Centripetal Force System (GDX-CFA) to help students gain insight into rotational motion. You can set...
The Go Direct® Centripetal Force System (GDX-CFA) requires the use of the Go Direct® Force and Acceleration Sensor (GDX-FOR) for sensor data collection. There are three primary channels that will be of use when using this sensor with the Go D...
The 3-step pulley has the following diameters:
20 mm
29 mm
48 mm
Go Direct Centripetal Force Apparatus, Troubleshooting and FAQs...
The mass of the Sliding Carriage will vary from unit to unit. We massed several, and found the range to be from 48.1 to 48.6 grams. For best results we recommended massing the carriage you are using.
Go Direct Centripetal Force Apparatus, Troubles...
The Go Direct® Centripetal Force System (GDX-CFA) ships with two mass carriages. One slides on bearings and is the primary mass holder for experimenting with masses rotating on the CFA. The second mass holder is designed to be affixed to the beam...
The rotational moment of inertia for the beam of Go Direct Centripetal Force Apparatus is 0.00498 kg m^2 (calculated). This is based on SolidWorks calculation. Experimentally-derived values with Go Direct Force and Acceleration sensor attached were w...
This information pertains to the original LabQuest.
If you have LabQuest 2, see this article.If you have LabQuest 3, see this article.
Normally, the original LabQuest turns on in less than 90 seconds and displays the Meter screen (the screen th...
The LabQuest Emulator will not be able to communicate with a LabQuest over USB if a newer USB device driver has been installed by another application. The newer USB device drivers were first distributed in May, 2016 by the following products:
Logg...