The Go Direct® Acceleration Sensor (GDX-ACC) is sized to fit inside some rocket tubes. The Centuri Standard Tube ST-11 and the Estes Body Tube BT-55 are the smallest body tubes that will hold the Go Direct Acceleration. The sensor can be place...

Go! Motion (GO-MOT) Specifications and User Guide Which Motion Detector model do I have? Troubleshooting Primary test: When you start data collection, do you hear a clicking from the Go!Motion? If not, the sensor may...

Below is a thorough list of Vernier equipment that supports AP Physics 1 and 2. Since no two physics instructors teach AP physics in exactly the same way, this list may not have everything needed or may include sensors that are not needed in your cu...

Most of our curve fitting (except for very simple fits, like linear) is done using a non-linear n-dimensional search following methods described in books like Data Reduction and Error Analysis For the Physical Sciences, by Bevington and Robinson. Th...

LabQuest 2.8.1 • Various bug fixes related to using Go Direct Sensors via USB LabQuest 2.8 • Go Direct Sensors via USB connection • Addressed an issue where units left in a suspended mode for five days could leave the LabQuest in an unus...

This information pertains to LabQuest 2. If you have a LabQuest 3, see this article. If you have an original LabQuest, see this article. If your LabQuest 2 partially turns on but doesn't load the LabQuest 2 app all the way, it is possible to recov...

Many instructors use Vernier equipment as part of the International Baccalaureate (IB) program. Correlations between Vernier lab activities and the IB curriculum are available at: https://www.vernier.com/ib-correlations/ FAQs when using Vernier prod...

When you attempt to Launch Graphical Analysis on Windows, you may get an error message as follows: This is caused by a missing or corrupt Microsoft Visual C++ redistributable. To fix this do the following: Go into Add/Remove Programs and ...

There are two sets of mounting holes on the Vernier wired (BTA) accelerometers for attaching the accelerometer firmly to an experiment setup, when necessary. Each pair of mounting holes is 30 mm apart (measured center-to-center). Each mounting hole ...

Go Direct® Force and Acceleration Sensor (GDX-FOR) Specifications and User Guide Troubleshooting General: Press the power button on the sensor to turn it on. Connect your sensor as described in the Getting Started instruct...