For new Force plates and new calculators the answer is most likely NO. Whether or not a force plate works with a TI calculator depends on three things: the version of the sensor, the interface required, and whether or not your calculator supports...

As the Cart Fan (DTS-CFAN) is operated, its battery level decreases. The Cart Fan firmware includes code that maintains the fan thrust as the battery level changes. If the Cart Fan determines that the selected thrust cannot be maintained given the ...

If your Cart Fan (DTS-CFAN) does not turn on when you press the Start/Stop button, check the following: Does the Cart Fan need to charge? Try plugging it in power. If the charging LED turns on, it is likely that it is just low on battery and nee...

Cart Fan (DTS-CFAN)Specifications and User Guide TROUBLESHOOTING– Primary Test: Press the Start/Stop button. The fan should turn on. Select a thrust level using the Selection button and press the Start/Stop button. The Thrust/Duration Indicator...

Vernier does not sell holders or storage racks for our oxygen gas sensors. But the shaft of both the Go Direct O2 Gas Sensor and the O2 Gas Sensor can be placed in 50 mL conical tubes, which can also be called a 50 mL centrifuge tube. This means tha...

For Go Direct sensors with multiple sensor channels, connect the sensor, then follow the instructions below to change the sensor channels used for data collection. Table of Contents● Instructions for Graphical Analysis● Instructions for L...

The USB Digital Microscope has an effective optical magnification of 100x. You can then use the digital zoom feature in different software titles to get to a maximum of 300x before the image gets too pixelated. Please be aware that to see images at ...

This issue is related to the package (or installed) versions of our Apps.If you are using the Progressive Web App versions, see How do I connect USB sensors to the Progressive Web App version of Graphical Analysis (and other Vernier apps)? Only t...

This information pertains to the pre-November 2023 version of the Force Plate (FP-BTA) (shown here). It is common for the force plate to provide a non-zero value after hard impacts. This may be the result of a permanent bending of the l...

A new Manual Fit feature was introduced with version 6.0 of Graphical Analysis Pro, released in April 2024. A Pro subscription is needed to access the feature.  With manual fitting, you can adjust a line superimposed on a graph, and the slop...