If the number of decimal places displayed in the software does not match the display on the balance, you can change them by doing the following:
1. LabQuest App: Tap the Table tab. Choose Data Column Options▶Mass from the Table menu. Change...
The Force Plate, like any sensor, has a limit to how quickly it can respond to a change. If a very short impulse is applied to the force plate, it will vibrate, or ring, for a short while. That ringing can interfere with your measurement.
Revis...
Magnetic Field Sensor (MG-BTA)
Specifications and User Guide
Troubleshooting
Primary Test: Confirm that the setting switch on the sensor wand is appropriate for the experiment. The low amplification (6.4 mT range) is used...
Yes, O2 gas concentration can be expressed in units of mg/m³. However, the value is dependent upon temperature and pressure.
At Standard Ambient Temperature and Pressure (SATP), 25°C and 100 kPa, the conversion is:
1% O2 = 12,912 mg/m³
Logger P...
Yes, CO2 gas concentration can be expressed in units of mg/m³. However, the value is dependent upon temperature and pressure.
At Standard Ambient Temperature and Pressure (SATP) of 25°C and 100 kPa, the conversion is:
1 ppm CO2 = 1.7758 mg/m³
L...
The FLIR ONE® Thermal Camera for iOS (FLIRONE-IOS, discontinued) requires an iOS device with Lightning connector, such as iPad, iPhone, or iPod touch.
Not all devices with a lightning connector will support all features of the Thermal Analysis so...
Using Logger Pro:
1. Choose the column you wish to change from Column Options under the Data menu.
2. On the Column Definition tab, change the Data Type to Date, Date & Time, or Time of Day.
3. Choose the desired format.
4. Click Done.
Using Lab...
The black thumbscrews shipped with DFS-BTA units are just short enough to allow Mass for Dynamics Cart (MASS), to be attached to the cart at the same time as the force sensor. You will need the larger accessory post from the Fasteners for Dual-Range ...
Below are links to experiments with various aspects you could investigate in conjunction with the green roof project. Some of these have been done by other educators as more of a project than a simple 45 minute lab.
Effect of Color
https://www...
It is possible for a Motion Encoder to incorrectly announce its name to the software, causing the Auto-ID feature to fail. This issue is likely to be intermittent, as it is often caused by a bad connection. If the Motion Encoder Receiver is identifie...