The first batch of Go Wireless® Link (GW-LINK, discontinued) had a firmware bug that affected how the device reads the auto-ID resistors in our sensors. If the Go Wireless Link reads the resistor incorrectly, it incorrectly identifies the sensor. ...

Yes. The force sensor will auto-ID when using Logger Lite. If you are using only the force sensor, you are ready to go after starting Logger Lite and connecting the VSMT. Note, however, that the displacement sensor will not auto-ID, nor can it b...

Yes. With the proper app and supported motion detector, you can do graph matching with most TI graphing calculators. Note: For instructions on installing calculator apps and programs, see our App and Program Transfer Guidebook. TI-Nspire CX II a...

For new calculators, No. For most older calculators, Yes. In addition to the Drop Counter (VDC-BTD), you will need software and a sensor interface appropriate for your supported calculator. Note: For instructions on installing calculator apps a...

For new calculators, No. For most older calculators, Yes. In addition to the Rotary Motion Sensor (RMV-BTD), you will need software and a sensor interface appropriate for your supported calculator. Note: For instructions on installing calculat...

For new calculators, No. For most older calculators, Yes. In addition to the Vernier Radiation Monitor (VRM-BTD), you will need software and a sensor interface appropriate for your supported calculator. Note: For instructions on installing calc...

You can distinguish between older and current versions of the Magnetic Field Sensor (MG-BTA) based on the appearance of the sensor. Current -Black plastic shaft with a swiveling head and a white dot at the end of the tip -Range switch on the sha...

It is not necessary to perform a new calibration when using the Light Sensor (LS-BTA) in the classroom. You can simply connect the sensor to a Vernier data-collection interface and start your Vernier data-collection program. When the sensor is automa...

EKG Sensor (EKG-BTA) Specifications and User Guide Troubleshooting Primary Test: The most common cause of problems with this sensor is a poor connection, either between the tabs and the skin, or between the clips and the tabs...

Short Answer: Yes. Use Logger Pro versions 3.10.2 through 3.15. Longer Answer: Apple released Mac OS X 10.11 (El Capitan) on September 30, 2015.  Apple (and Vernier) typically support any given major OS version for 3 years with newer software vers...