Yes. KidWind Project® has worked closely with Vernier to produce a series of experiments to quantify the power and energy output of Kid Wind’s wind turbines, solar cells, and fuel cell products. We have found this hardware and software easy to use...
We have been collaborating with the Great Lakes Bioenergy Resource Consortium, and they have developed a series of exercises on fermenation and biofuels that use Vernier probeware. You can find the educational materials at:
http://www.glbrc.org/ed...
This information pertains to the original LabQuest and LabQuest 2.
If you have a LabQuest 2, see this article.
Before following these instructions to add the driver for the HP LaserJet Pro 400, your LabQuest version must be 1.7 or LabQuest 2 mus...
Short answerMore than you would need for just about any experiment.The internal memory allows you store a lot of data, both in one file, and across many files. Since data files take up very little storage compared to pictures, we have not seen the a...
The column inside the Mini GC and Mini GC Plus is a Restek MXT-1 stainless steel capillary column with dimethyl polysiloxane. Injecting anything through the column that is not on the approved list of compounds (see the accompanying booklet or online)...
No. The Optical DO Probe is not calibrated to measure oxygen gas in air nor can it be calibrated for this measurement.
If you want to measure oxygen gas, you may want to consider the O2 Gas Sensor (O2-BTA).
...
It depends on the sensor. The following is a list of the common Water Quality sensors and their resistance to salt water.
Temperature Probe - The stainless steel should do fine.
pH Sensor- It is a potentiometric sensor. Since the sample presents an...
Yes. Traditionally, a solution of sodium sulfite is used as the zero-oxygen calibration solution but this is NOT recommended for the Optical DO Probe. A zero-oxygen calibration solution can be created by bubbling nitrogen gas into distilled water.
...
Manual configuration mode is a special mode of Logger Pro designed for instructors wishing to have their students set up data collection and graphing themselves. Logger Pro will no longer set data-collection rate and duration, and graphs will no long...
Graphical Analysis and Graphical Analysis Pro use a network service called "Bonjour" to automatically discover data sources (LabQuest 2, LabQuest 3 or Logger Pro). On networks that do not allow Bonjour, you will need to manually connect to the data...