High Current Sensor (HCS-BTA) Specifications and User Guide Troubleshooting Primary Test: Plug the probe into an interface and run the data collection program. Use wire leads to connect the probe to a DC supply with a known ...

The 30-Volt Voltage Probe (30V-BTA) probe was designed to monitor alternative energy sources like large solar panels or wind turbines. The unit has a 30K ohm input impedance. This is low enough compared to the the usual input impedance of multimeters...

Two types of cords are included with our PAAS-PAMP, Speaker Accessory. The most accurate thing to do is to weigh the string and measure its length and calculate the mass per unit length. We may, over time, change our supply of this cord. As of ...

30-Volt Voltage Probe (30V-BTA) Specifications and User Guide Troubleshooting Primary Test: See if the sensor is automatically recognized by the software Secondary Test: Apply a voltage across the leads and see if the ...

If your CO2 Gas Sensor no longer auto-IDs and is still under its 5-year warranty, you can return it to Vernier for inspection (see below). If it is a mechanical problem, it will be fixed at no charge under the warranty. If, however, it is determined ...

There is 0.23 g of silver metal and 0.002 mg/L AgCl in our pH sensors. These are both under the federal limits of waste disposal (but please check your state and local regulations as well). Therefore, there is no hazardous chemical in the sensor limi...

We do not carry adapters that will allow you to connect Vernier Sensors to Data Acquisition Systems (DAQs) from ADI, BIOPAC, or IWORX. We also do not carry adapters that will allow you to connect ADI, BIOPAC, or IWORX sensors to a Vernier Interfa...

Mini GC Plus: Quick Guide Parameters to the Compounds *Always start by measuring a pure compound to see if your mixture and/or unknown can be detected by the Mini GC Plus. See a list of compounds that can be detected here: Vernier Mini GC Plus (GC2-...

The calibration button on the CO2 Gas Sensor can become stuck in the depressed position by being caught under the edge of the plastic. If this has happened, the red LED will not flash and the sensor will not calibrate when the button is pressed. This...

The first experiment in our book Nuclear Radiation with Vernier (NRV-E) is all about this subject. Details and the table of contents can be found at https://www.vernier.com/nrv The following is an excerpt from Nuclear Radiation with Vernier: T...