Neither Logger Pro nor Vernier Video Analysis automatically creates x and y acceleration columns for video analysis projects. We chose not to create acceleration columns automatically because the quality of video analysis position data is generally ...
Many people want use our software without having to install it on the computer they are sitting at. This can be because IT policies don't allow them to install software or can be a way to save time. If you are using a computer or Chromebook running ...
Ideas found in the User Manual
Analyze a crouched jump. Start with knees bent, hands on hips. Do NOT lower your body further; jump up only. Do not move your arms. This very artificial jump is easier to analyze than a natural jump.
Use the impul...
One thing to check, which is difficult to notice is:
Are both of the power bricks on the power cord connected properly? If only one is connected, the power lamp on the Power Amplifier will come on normally, yet you will get now output from the PAM...
The illumination value is a measure of the light, originating from the LED source, that reaches the light detector. The illumination value is reported in relative units because all the measurements made with the Polarimeter are made in reference to a...
Yes! We have made example experiments available, free of charge.
If you are using the Chemical Polarimeter, those experiments can be downloaded here.
If you are using the Go Direct Polarimeter, those experiments can be downloaded here.
Both versions...
The standard in polarimetry is to use a 10 cm pathlength which is approximately 25 mL in our sample cell. However, because it is not always feasible to have this large a sample volume, you can accurately take readings with sample heights lower than 1...
Short Answer
This is a bit of a gray area. The short answer is "If the video can be loaded and played in Vernier Video Analysis or Logger Pro, then you can use the analysis tools to analyze the video."
Long Answer
The long answer is tha...
This information pertains to the original LabQuest and LabQuest 2.
If you have a LabQuest 3, see this article.
Before following these instructions to add the driver for the HP LaserJet P2035 or HP LaserJet P2035n, your LabQuest version must be 1...
The meter on the sensor reports count rate in various units such as counts per second, but our software reports total counts during each time interval, not count rate. The units displayed in Logger Pro thus are "counts" and not, for example, counts p...