The can operate in either voltage-control or current-control modes, and so has both current and voltage control knobs. Most instructors are familiar with power supplies......
After upgrading from earlier versions sometimes you will get a message saying “The ordinal 18 could not be located in the dynamic link library VGPS_SDK.dll”......
You do not need to use 4-sided clear cuvettes to measure fluorescence with the SVIS-PL. A standard two-sided clear cuvette will work as long as......
Vernier pH sensors are not designed to be stored dry, but our sensors are pretty tough and the pH sensors can survive being stored dry......
Vernier products are designed to be used by students in a classroom. We do not build products for weather balloons. However, some educators have made......
You can install magnets in the so that dynamics carts elastically bounce off the End Stop at low speeds. But the magnets must be installed......
To manually set up a nonauto-ID sensor in DataMate perform the following steps: 1) Connect the sensor to channel CH 1 on the LabPro or......
Recent versions of Logger Pro (3.5 and newer) allow a dynamic numeric range of 1.1e-99 to 1e99. Older versions have more limited range. If a......
The current sensor function of the can be used at the same time as the analog out function of LabPro, but the procedure is not......
None of the Vernier interfaces, e.g. LabPro, will connect directly to the Fourier MultiLog. In order to collect data with the MultiLog and Vernier sensors,......