This is a Windows-only problem.
Logger Pro requires Bluetooth radios that use the Microsoft driver. Some third-party drivers will allow Logger Pro to see the WDSS, but will not work properly to provide data communication. For these drivers, you'll...
If you want to build your own sensors, connect Vernier sensors to your own interface or build your own cables, extensions, interfaces, or adapters. Here is how to get all the connectors and sockets we use.
We chose these connectors because they c...
Yes, Bumper and Launcher Kit (BLK) will fit PASCO tracks.
As shipped, the mounting screws and nuts are positioned to fit the Vernier track. You'll see a secondary pair of holes adjacent to the mounting screws. Move the 1/4-20 nylon screws to the ...
Our Power Amplifier will not be automatically recognized by either LabQuest App or Logger Pro. To use it and control the output you need to follow the instructions below.
If you are using the LabQuest App (no computer), you want to use the built-in ...
Logger Lite will display the message "No Device Connected" or "no sensors detected" when a device such as a Go!Temp or LabQuest cannot be found. Below are troubleshooting steps to solve the most common problems.
If you have multiple computers and in...
We have done some testing to see how much current is drawn by the LabQuest charging station. Below are some data. Note: All these tests were done at 120V AC in the U.S.
- When the charging station is plugged in, but no units are charging, the current...
After upgrading the LabPro with Logger Pro 3.1 or 3.2, if you start the DataMate application and do not use the [CLEAR] button on the Main Screen to refresh the setup, your motion detector may not collect good data. The motion detector will appear t...
ChemBio, Physics, and PhySci programs were developed for the original CBL. While you can use them with the CBL 2 or LabPro, we recommend EasyData or DataMate instead.
Which TI Calculators work with the CBL 2 or LabPro?
...
This is a hardware defect in the data acquisition board (DAQ). The unit needs to be repaired. Please contact Vernier Technical Support to set up a Return Merchandise Authorizaton (RMA).
...
This information pertains to the original LabQuest.
If you have LabQuest 2, see this article.
There have been reports of LabQuest units freezing when the units are in a low battery condition and then connected to AC power. Symptoms of the freeze a...