Yes. The sensors that were included with the original CBL (starting in 1994) autoID and work fine with a LabQuest interface (any model) or a......
To get the most accurate readings from the Voltage Probe, when measuring the half cell potential in a chemistry experiment (such as Lab 28 from......
Experiments that are written for the or the can be performed with standalone voltage and current probes, but you will need to set up the......
A small number of LabQuest 2 units shipped in the Fall of 2016 that have an improper internal calibration. These LabQuests read certain sensors poorly.......
Due to the simple nature of the sensor, the ±10 V may not read 0 V when the leads of the sensor are not connected......
You can use the standard , to do Ohm’s Law experiments. There are two things you need to watch out for, and for these reasons......
The output of the Vernier , is bipolar. The negative terminal is not quite at ground, because of the presence of a small current sense......
Special caution should be taken when operating at greater than ±20 volts in a situation where significant current can be supplied. Many solar panel projects......
The key difference is that the black leads on the simple Voltage Probe (VP-BTA) are connected to ground of the interface when used. That means......
The SensorDAQ voltage probes only give a meaningful reading when they are connected to something. When the leads are not connected to anything, ignore the......