Go Direct® Energy Sensor (GDX-NRG)
Specifications and User Guide
Troubleshooting
General Test: Press the power button on the sensor to turn it on. Connect your sensor as described in the Getting Started instructions for yo...
You will find two sets of letter number pairs separated by a colon in the bottom right hand corner on the bottom label of the SpectroVis Plus (SVIS-PL, discontinued).
The letter and number pairs correspond to the firmware and hardware revision of the...
Instructors, sign in to your Vernier web account at https://www.vernier.com/account/. This will take you to the My Downloads page of your account. If you are already logged in, hover over My Account in the upper-right corner of any page on our we...
Go Direct® Radiation Monitor (GDX-RAD)
Specifications and User Guide
Troubleshooting
General: Connect your sensor as described in the Getting Started instructions for your device. Verify that the Radiation Monitor is autom...
Logger Pro 3 is no longer sold and will no longer receive updates.To use this feature, you must already own a Logger Pro license.Logger Pro v3.16.2 if the final release of Logger Pro.
The purchase of Logger Pro 3 software includes a site license ...
You will need the larger attachment screw included with the Dynamics Cart and Track System Fasteners for Force Sensor and Accelerometer (DTS-ACC) or the one included with Dynamics Cart and Track System (DTS).
See the photos below for the correct ...
The Power Amplifier (PAMP) is designed to amplify output both AC and DC signals from a LabQuest. If you find that you cannot get a DC output voltage from the Power Amplifier, try the following:
1) Investigate the signal generator. If you are using a...
Logger Pro 3 is no longer sold and will no longer receive updates.For more information, see Logger Pro will no longer receive updates.
The purchase of Logger Pro 3 software includes a site license that allows you to install Logger Pro 3 on any co...
Logger Pro 3 is no longer sold and will no longer receive updates.To use this feature, you must already own a Logger Pro license.Logger Pro v3.16.2 if the final release of Logger Pro.
Instructors, sign in to your Vernier web account at https...
When using the LabQuest Viewer with a LabQuest and Go Direct sensors, you may find that the list of discovered Go Direct sensors will not show up on the LabQuest Viewer's display. This is because there is bandwidth competition between the Bluetooth...