The information that follows is for LabQuest Viewer App for iPad. If you are looking for information about the LabQuest Viewer software for Windows and Macintosh computers, see LabQuest Viewer Computer Software Troubleshooting and FAQs System Requir...

A screen shot can be used by students when creating a lab report or by instructors who want to write their own experiments. If you want to capture a screen shot of a LabQuest 2 or LabQuest 3 screen, there are several options. The easiest option is ...

Since network connections can temporarily drop due to network interruptions, the networking stack holds onto the old IP addresses of LabQuest devices for a period of time, even if LabQuest is turned off or the connection is intentionally disconnected...

The information that follows is for LabQuest Viewer software for Windows® and Macintosh® computers. If you are looking for information about the LabQuest Viewer App for iPad®, seeLabQuest Viewer App for iPad Troubleshooting and FAQs LabQuest V...

This document is a list of things that are new or different in LabQuest 2 (vs. original LabQuest)How does LabQuest 3 compare to LabQuest 2? General changes for LabQuest support: Use with touch (New) or stylusNew larger, high-resolution screenN...

For the purpose of identification during device discovery, the LabQuest Stream serial number has been set as the name of the interface. This eight-digit number is printed on the label located on the back of the unit. The LabQuest Stream pictured belo...

To move a picture from LabQuest to a computer you will first need a micro SD card (LabQuest 2 only) or USB flash drive. Insert your USB/SD card into LabQuest. Launch the Camera AppLabQuest 2⚊Tap Home > Accessories and select the Camera AppLab...

There is a problem with some high-speed USB connections on computers running Windows 7. This is a problem especially with laptop computers. The symptom of this problem is that your LabVIEW VI, or the Analog Express VI, will read from an analog sensor...

This problem shows up both as noise and as a change in calibration of the Dual-Range Force Sensor when the Motion Detector is used at the same time with a LabPro interface. The problem does not happen with all Dual-Range Force Sensors, and it does no...

If you are using a DIY kit, which requires you to build your own tower and base, follow these instructions to create a tower from polyvinyl chloride (PVC) pipe. Parts Needed 90° PVC fittings (4) 6" PVC pipe sections (6) PVC T-fittings; drill a...