The Dynamics Cart and Track System with Motion Encoder (DTS-EC) can show a drift in the zero position of the cart when connected to a LabQuest when powered by certain AC adapters. This can be seen by leaving the cart stationary, and monitoring the po...
LabQuest App version 2.4 or newer (original LabQuest version 1.7 or newer) has the following calculated column equations:
X&Y are data columns; A,B,C,D are single values
X+A
X-A
AX
X/A
A/X
AX+B
AX2+BX+C
AX3+BX2+CX+D
ABX
AX^B
ABX^C
A/X^B
A/(B+X)...
To share a Vernier Video Physics project via YouTube, use the following steps.
1) Capture and analyze your movie.
2) Tap the Share button.
3) Choose either Video or Video with Points.
4) Tap Save Video.
5) Leave Video Physics and launch the Phot...
This information pertains to the original LabQuest.
If you have LabQuest 2 or LabQuest 3, see this article.
To connect an original LabQuest to a network, you need a Vernier Wi-Fi USB Adapter (WIFI-USB, discontinued).
Insert the Vernier Wi-Fi...
This information pertains to LabQuest 2 and LabQuest 3.
If you have an original LabQuest, see this article.
Follow these steps to connect a LabQuest to a Wi-Fi network.
Tap the Wi-Fi icon in the LabQuest toolbar to launch the Connections app...
Both Pasco and Vernier have made many different sensors and interfaces in the last 20 years, so there is no simple and quick answer to this question. This document is meant to answer most common questions. If you have a compatibility issue that is n...
Nitrate Ion-Selective Electrode (NO3-BTA)
Specifications and User Guide
Troubleshooting
Primary Test: Check the raw voltages while calibrating in the standards. The high (100 mg/L) should be around 1.6 volts. The low (1 m...
Calcium Ion-Selective Electrode (CA-BTA)
Specifications and User Guide
Troubleshooting
Primary Test: Check the raw voltages while calibrating in the standards. The high (1000 mg/L) should be around 1.9 volts. The low (10 ...
Do not disassemble the probe for this type of cleaning. Swirl the tip of the probe in a 1:10 dilution of household bleach with water for ~10 seconds. Rinse well with DI water. NOTE: Do not submerge the entire probe. The "handle" is not waterproof....
Do not disassemble the probe for this type of cleaning. Swirl the probe in a 1:10 dilution of household bleach with water for ~10 seconds. Rinse well with DI water....