If the Energy Sensor seems to produce noisy readings proceed as follows:
1. Zero the Sensors on the VES while shorting out the Source terminals. Remove the short.
2. If connected to a wind turbine, try a more stable source like a battery or even a ...
For Go Direct® Energy Sensor (GDX-NRG)
Graphical Analysis App⚊Free download at: https://www.vernier.com/products/software/graphical-analysis/Graphical Analysis Pro⚊subscription based upgrade to the Graphical Analysis AppLabQuest 2⚊versi...
This article specifically refers to the use of the KidWind MINI Wind Turbine with Blade Design (KW-MWT) and KidWind MINI Wind Turbine with Blade Design (KW-MWTBD) with the KidWind Red Blade Set (KW-RED). If you suspect your generator does not work an...
If you have confirmed that your KidWind Mini Wind Turbine is incorrectly wired inside the nacelle, and you wish to repair it yourself, this is how we recommend making the repair.
Materials needed:
flat head screwdriv...
If the LabQuest 2 update fails to reprogram the fuel gauge successfully, apply the update again. For most units, a second update will reprogram the fuel gauge as expected. This error is likely caused by the state of the fuel gauge when the update is ...
Currently you can analyze videos, but not still images with Video Physics for iPad....
Windows 8.1 was release in October 2013. The following outlines Vernier application behaviors for Windows 8.1
Logger Pro
Logger Pro version 3.8.6.2 and higher have received extensive testing with Windows 8.1.
Why does my Go!Link or GC Mini fa...
Some standard ladders of DNA won't form a perfectly linear standard curve. An example is attached. This is normal and can occur when there is a wide range of fragment sizes. In the case of Fig. 1, the bands range from 10,000 to 300 base pairs. The da...
This information pertains to the original LabQuest and LabQuest 2.
If you have a LabQuest 3, see this article.
This issue pertains to original LabQuest v1.7 or older or LabQuest 2 v2.1 or older.
Some original LabQuest and LabQuest 2 units have a...
Note: the instructions below refer to using CH 1 for clarity; however, any channel can be used.
Instructions for LabQuest 2 and LabQuest 3
1) Connect the sensor to channel CH 1* on the LabQuest.
2) Choose Sensor Setup from the Sensors menu....