The Force Plate (FP-BTA) and Go Direct® Force Plate (GDX-FP) will measure compression and tension forces, normal to the flat top surface of the plate. The plate is designed to measure larger compression forces than tension. The original version (...
Below are a list of sensors that DO NOT work with an EasyLink. For a list of sensors that do work with an EasyLink, see the Compatible Sensors tab on the EasyLink web page.
The list indicates the EasyLink limitation followed by the sensors that...
Logger Pro 3 is not sound-enabled and does not recognize the sound files if you try to browse the LabQuest. Here is how to get the audio clip from LabQuest to a computer and play it.
When you save a LabQuest audio clip, save the file to an attached ...
Ideally, when you are performing the saturated DO calibration point with the sensor in the bottle above a small amount of water, the air in the bottle and the water should be the same temperature. This is the temperature you would look up on the char...
The D.O. Filling solution recipe is a proprietary recipe owned by our electrode manufacturer. We do not have that recipe and are not able to distribute it to customers.
The probe manufacturers feel strongly that people making up their own solutio...
Yes, the DO Calibration Solution (sodium sulfite) can be purchased as DO Calibration Solution (DO-CAL). Note that this is for the original Dissolved Oxygen Probe, not for the Optical DO Probe....
Most people who experience difficulty with DO Probes do so because they do not use the proper setup and/or calibration procedures. The procedure for calibration can be found in the DO Probe booklet that came with the sensor (or found online at www.ve...
https://vimeo.com/60666407
The video above walks you through how to make a cliphub using a KidWind Hub (KW-WTH3), wooden dowels, bulldog clips, and a hot glue gun. Making a cliphub allows students to test and try their blades at any angle and w...
Current Probe (DCP-BTA)
Specifications and User Guide
Troubleshooting
Primary Test: Plug the probe into an interface and run the data collection program. Use wire leads to connect the probe to a DC supply in series with a know...
Yes. LabQuest 2 and LabQuest 3 built-in GPS is WAAS-enabled (Wide Area Augmentation System). This system utilizes additional data to increase location accuracy (North America and Hawaii only). Accuracy is still dependent on the number and current g...