This is likely the result of the LabQuest desktop software not functioning as expected. To verify this, close all applications and quit the LabQuest Application (File > Quit). If the LabQuest shows a blue screen with Vernier on the side, the desktop ...
LabQuest platforms include an internal speaker and the Audio Function Generator app. The speaker can be used to hear a waveform produced using the Audio Function Generator, but due to the small size of the speaker, harmonic distortion is significant...
In September 2012, we updated the Conductivity probe with a new calibration on each switch setting to optimize it for small improvements in the hardware.
Pre-Sept 2012 Calibration values:
Low Setting = 65.7 uS/cm
Middle Setting = 847.2 uS/cm
...
The LabQuest internal temperature sensor measures temperature inside the LabQuest case. Its calibration is adjusted to approximate ambient temperature, but can deviate depending on the battery charge state and freshly powered warm-up time.
The ...
This information pertains to the original LabQuest.
If you have LabQuest 2, see this article.
If you have a LabQuest 3, see this article.
If the screen is not responding, try pressing the Home hardkey on the face of the unit. If the menu comes ...
The High Current Sensor uses a Hall-Effect sensor to measure the current. The Hall Effect is a magnetic phenomenon, so a strong magnetic field in the area the HCS-BTA sensor could cause a erroneous reading. Examples might include a electric motor or ...
This information pertains to the original LabQuest.
If you have LabQuest 2, see this article.
If you have LabQuest 3, see this article.
If you receive a "No Battery" message on your LabQuest, it is most likely because the battery wiring harness ha...
This information pertains to the original LabQuest.
For LabQuest 2, see this article.
For LabQuest 3, see this article.
If the computer can see the LabQuest update file, but the LabQuest can not, the update file probably needs to be unzipped fi...
This information pertains to LabQuest 2.
The original LabQuest and LabQuest 3 do not have this functionality.
LabQuest 2 with Lab Armor installed will not fit in the LabQuest 2 Charge Station (LQ2-CRG). However, it is possible to remove the Lab Ar...
The Power Amplifier can amplify any signal sent to it up to 15 kHz. LabPro has a built-in function generator, which goes up to 166 Hz.
If you need higher frequencies, there are several options:
- Use our free Power Amplifier Function Generator ...