Stir Station (STIR)
Specifications and User Guide
TROUBLESHOOTING
-Primary Test (using C batteries): Place a 250 mL beaker, with about 100 mL of water, on the platform of the Stir Station. Place a magnetic stirring bar in the beaker of water and tur...
From Vernier
Both Vernier Video Analysis and Logger Pro 3 include prepared videos students can analyze.
Vernier Video Analysis includes 9 sample videos ready for students to analyze. In the launch window, scroll down to see all of the sample ...
This sensor is no longer available. Information is presented for reference only.
Student Radiation Monitor (SRM-BTD, discontinued)
Specifications and User Guide
Troubleshooting
Primary Test: Is the 9 V battery good? Ar...
Respiration Monitor Belt (RMB)
Specifications and User Guide
Troubleshooting
Primary Test: Is the belt properly attached to the Gas Pressure Sensor? It must be attached to a Gas Pressure Sensor (GPS-BTA).
Addition...
Some Light Sensors were produced with an incorrect sticker that labels the 3-position switch on the Light Sensor. The switch should be labeled:
Range (lux)
0-6000
0-600
0-150,000
If instead the switch is labeled with units of µS, the sticker...
Yes. If you use the LabPro Digital Adapter (DG-BTD), the ME-9259A will work with LabPro....
Yes, older non auto-ID sensors can work with EasyData. To use the older sensors you have to load special EasyData AppVar file(s) onto your calculator, then open one of the files using EasyData. The files that you need depend upon which interface (La...
(this TIL is about older software, and does not apply to Logger Pro.)
Several people have asked about how they can create their own challenge files for students in MacMotion or Motion (MS-DOS Version). By challenge files, we mean files like Distan...
The spacing of the grid lines in Logger Pro are automatically determined based on the axes limits in the graph. You can adjust the axes limits to change the spacing, but there is no way to specify that a tick mark display every x units.
You can adju...
The Vernier-branded Rotary Motion Sensor (RMV-BTD) can not ID on in Logger Pro when used with a LabPro interface because the LabPro firmware was created before this sensor. There is no plan to update the LabPro firmware.
There are workarounds:
1. Ma...