You can now use our wireless Go Direct sensors with the Digital Control Unit (DCU) to control small electronic devices (e.g., motors, LEDs, and lights). Last year, you may recall, we added the capability to control the DCU from LabQuest 2. This year, when LabQuest 2 gained the ability to connect with Go Direct sensors, we once again expanded the DCU’s capability. Wirelessly connect your Go Direct sensor(s) to LabQuest 2, connect the DCU to LabQuest 2, and program the DCU to turn on components based on the sensor values.
With Go Direct sensors and the DCU, you can use output from a heart rate monitor to light up LEDs that help test subjects maintain a target heart rate. Or, if your students struggle to stay awake, you can have them create an alarm that triggers when carbon dioxide levels get too high in your classroom. You could even program a fan to turn on and bring in some fresh air!
We have also created a kit of components that run on DC power in order to make it easier for you to integrate the DCU into your classroom. The Digital Control Unit Power Output Kit contains lights, LEDs, and a motor, along with connecting wires. We believe this will make it much easier to integrate simple programming logic, the engineering design process, and process control concepts into your science or engineering classroom.
For those of you who may be new to the Digital Control Unit, the device is designed to turn on a DC powered electrical component based on simple logic statements (greater than or equal to, or less than or equal to) associated with sensor values or time. It can be set up and controlled in Logger Pro 3 software or the LabQuest app. Compound statements using “and”, “or”, “until” statements allow for fairly complex control. For more information go to Digital Control Unit page.