When reporting the resolution of a sensor, we are really reporting the smallest step size that a chosen interface can report from the sensor in question without seeing bit noise. This is not a measure of sensor accuracy.
Different interfaces use ...
Blood Pressure Sensor (BPS-BTA)
Specifications and User Guide
Troubleshooting
The Blood Pressure Sensor will not report blood pressure parameters unless data collection has started.
The data-collection software needs...
The Accessibility menu item was added to Logger Pro in 3.8, but the features were not well-implemented. For example, there was a way to that an audio tone corresponding to a sensor reading, but there was no way to control the volume. These options we...
The easiest way to analyze muscle activity is to use the EMG channel and the EMG rectified channel on the Go Direct® EKG Sensor (GDX-EKG). You can look at the difference between the maximum and minimum voltage over time to measure EMGs. This is t...
Yes, you will need our Instrumentation Amplifier (INA-BTA), one of our interfaces, and our Logger Pro software.
Almost any laboratory instrument that has an output designed to interface with a chart recorder can be connected to our Instrumentatio...
The LabQuest file periodic_table_data.qmbl is automatically generated the first time you select to open a LabQuest file. Updates to the data from the Periodic Table App, like those found in LabQuest 2.1, will not be reflected in the file automatica...
This information pertains to the original LabQuest.
If you have LabQuest 2, see this article.
If you have LabQuest 3, see this article.
Apply the LQ1.7_Reset_Defaults update to restore factory defaults for an original LabQuest. This update does...
Logger Pro is no longer sold and will no longer receive updates.Logger Pro version 3.16.2 is the final release of the software.
Symptom
When the Logger Pro installer is run, the Logger Pro 3 folder in Applications is updated with the new r...
If you enable the internal temperature sensor and get a reading of 79.3C (174.4F) this is most likely caused by a hardware problem on the unit. Contact Vernier Software and Technology Technical Support to arrange a repair....
If you are using the Polarimeter with a LabPro interface, please do the following:
1) Make sure you are using Logger Pro 3.8.5 or newer. To update your software, go to https://www.vernier.com/support/updates/logger-pro/
2) Only rotate the analyzer ...