UVB Sensor (UVB-BTA)
Specifications and User Guide
Troubleshooting
Primary Test: Are you using the UVB Sensor to check UVA light? Confirm that the sensor is appropriate for the experiment.
Secondary Test: Take readings...
A change in the manufacturing of the UVA Sensor (UVA-BTA) and UVB Sensor (UVB-BTA) causes some sensors to display with incorrect units in older versions of Logger Pro. Instead of showing mW/m2 (that should be a small superscript two) Logger Pro incor...
A mini UV Lamp can be purchased from Wards Natural Science, wardsci.com. The lightweight unit contains a six-inch tube that emits 365 nm longwave UV. It is composed on high-impact plastic and has an attached lanyard for easy handling. Four AA batter...
Note: This information pertains to the Hand Dynamometer (HD-BTA).
Yes, you can reattach them yourself using an adhesive specifically made for rubber and plastic. One such adhesive we use that is readily available online and at some stores is 3M Scot...
Hand Dynamometer (HD-BTA)
Specifications and User Guide
Original Version
Current Version
Which version of the Hand Dynamometer do I have?
Troubleshooting
Primary Test: Confirm that the sensor was properly zeroed. If th...
Voltage Probe (VP-BTA)
Specifications and User Guide
Troubleshooting
Primary Test: Connect the red and black leads properly and securely, according to the experimental setup.
Secondary Test: If you suspect that the rea...
New Sensor Support
• Vernier Optical DO Probe (ODO-BTA)
New LabQuest App Features
• Pivot Data for Data Matrix mode
• Digital Filter equations added for use in calculated columns
• Added range value (Δy) to statistics calculations...
Release Notes for LabQuest 2.1
New Sensor Support
• Ethanol Sensor (ETH-BTA)
• Goniometer (GNM-BTA)
• Vernier Mini GC Plus (GC2-MINI)
• Vernier Optical DO Probe (ODO-BTA)
• Pyranometer (PYR-BTA)
• Vernier Radiation Monitor (VRM-B...
This TIL is about a legacy interface no longer compatible with modern computers. It probably does not apply to you.
To calibrate your motion detector with the (MPLI, discontinued), do the following:
1) Start up the program and open a file th...
Logger Pro is no longer sold and will no longer receive updates.For more information see Logger Pro will no longer receive updates.
We strongly recommend that you use the Logger Pro MSI file as-is. We have tested on a wide variety of systems. Alt...