A crack at the end of the clear storage cap (where the sponge is located) does not affect the functionality of the Vernier Optical DO sensor.
A crack can commonly occur due to over-tightening the end of the storage cap. When placing the storage c...
In general, we do not recommend changing the setting on the Rotary Motion Sensor (RMV-BTD) to "left-handed" as opposed to the conventional, "right-handed" orientation in which counter-clockwise (anti-clockwise) is measured as positive angle values. H...
In most cases it is not necessary to calibrate sensors; however, for optimum accuracy you may choose to calibrate them manually.
To perform any calibration, you will need one or more external references for your sensor. For example, to do a two-p...
In order to calibrate a pH Sensor, or to confirm that a saved pH calibration is accurate, you should have a supply of pH buffer solutions that cover the range of pH values you will be measuring. We recommend buffer solutions of pH 4, 7, and 10. There...
The first batch of Go Wireless® Link (GW-LINK, discontinued) had a firmware bug that affected how the device reads the auto-ID resistors in our sensors. If the Go Wireless Link reads the resistor incorrectly, it incorrectly identifies the sensor.
...
Yes. The force sensor will auto-ID when using Logger Lite. If you are using only the force sensor, you are ready to go after starting Logger Lite and connecting the VSMT.
Note, however, that the displacement sensor will not auto-ID, nor can it b...
Yes. With the proper app and supported motion detector, you can do graph matching with most TI graphing calculators. Note: For instructions on installing calculator apps and programs, see our App and Program Transfer Guidebook.
TI-Nspire CX II a...
For new calculators, No. For most older calculators, Yes. In addition to the Drop Counter (VDC-BTD), you will need software and a sensor interface appropriate for your supported calculator.
Note: For instructions on installing calculator apps a...
For new calculators, No. For most older calculators, Yes. In addition to the Rotary Motion Sensor (RMV-BTD), you will need software and a sensor interface appropriate for your supported calculator.
Note: For instructions on installing calculat...
For new calculators, No. For most older calculators, Yes. In addition to the Vernier Radiation Monitor (VRM-BTD), you will need software and a sensor interface appropriate for your supported calculator.
Note: For instructions on installing calc...