This one of the more common forms of damage to a force sensor by a student.
What happens is that if the sensor gets hit hard, the strain gauge inside bends to one side and stays there (usually pushed in). If the sensor is working correctly the ra...
A Wireless Dynamics Sensor System (WDSS), Wireless Dynamics Sensor System (WDSS), can be connected to a PASCO dynamics cart using the included base plate and hardware.
The plate connects to the cart using two 10-32 x 1/2" flat head screws thro...
If the calibration screen does not respond to taps as described in:
Why is my LabQuest 2 screen unresponsive or acting like I am tapping on the wrong spot?
try the following:
1) Press the escape hard key (this is the ba...
Automatic Installation
Before manually installing the driver, attempt to install the driver automatically. For instructions, seeMy Windows computer fails to install a driver for using LabQuest Viewer with a LabQuest 2 or LabQuest 3 via USB conn...
An "Emboss Graph" option is available in Logger Pro version 3.8.7 and newer (Windows only). The feature has been tested on only the following embossers:
Emprint SpotDot Ink & Braille Embosser
ViewPlus Cub Jr. Braille Embosser
EmBraille...
The control knob on the Melt Station is held in place with two set screws. The drive size of the set screws is 1.5 mm. Vernier does not supply or sell a wrench for the set screws. However, you can purchase an inexpensive 1.5 mm hex wrench at any most...
No. Logger Pro for Linux is no longer available for download. If you already have a copy of the software, you can continue to use it; however, no new downloads or updates are available.See: Linux support for Graphical Analysis Progressive Web App
...
There are two different radiation cables in circulation due to differences in radiation monitor design. They are not interchangeable, so only use the cable that came with your particular radiation monitor.
The cables can be distinguished easily, as ...
If you are using the Motion Encoder Cart (DTS-CART-MEC) on a long 2.2 m track, you will need to adjust the emitter to the 2 m setting. The switch is located directly under the tab used to open the battery compartment.
The IR transmitter on the...
Make sure you are using a version of the software that was released after the Encoder system was invented.
For Logger Pro, version 3.8.6.2 or newer is needed.
For Original LabQuest, version 1.7.2 or newer.
For LabQuest 2, version 2.3.3 or newer.
For...