Hand Dynamometer (HD-BTA)
Specifications and User Guide
Original Version
Current Version
Which version of the Hand Dynamometer do I have?
Troubleshooting
Primary Test: Confirm that the sensor was properly zeroed. If th...
Voltage Probe (VP-BTA)
Specifications and User Guide
Troubleshooting
Primary Test: Connect the red and black leads properly and securely, according to the experimental setup.
Secondary Test: If you suspect that the rea...
New Sensor Support
• Vernier Optical DO Probe (ODO-BTA)
New LabQuest App Features
• Pivot Data for Data Matrix mode
• Digital Filter equations added for use in calculated columns
• Added range value (Δy) to statistics calculations...
Release Notes for LabQuest 2.1
New Sensor Support
• Ethanol Sensor (ETH-BTA)
• Goniometer (GNM-BTA)
• Vernier Mini GC Plus (GC2-MINI)
• Vernier Optical DO Probe (ODO-BTA)
• Pyranometer (PYR-BTA)
• Vernier Radiation Monitor (VRM-B...
This TIL is about a legacy interface no longer compatible with modern computers. It probably does not apply to you.
To calibrate your motion detector with the (MPLI, discontinued), do the following:
1) Start up the program and open a file th...
Logger Pro is no longer sold and will no longer receive updates.For more information see Logger Pro will no longer receive updates.
We strongly recommend that you use the Logger Pro MSI file as-is. We have tested on a wide variety of systems. Alt...
We haven't sold the Student Radiation Monitors for several years. Although we are often able to repair sensors outside of their 5-year warranty, we no longer have the parts to complete this repair.
If you are interested in replacing your radiation...
This issue shows when starting a VI to use the WDSS, he would get the following error notification.
"Error 1097 occurred at Call Library Function Node in BlueIO_SearchForDevices.vi -> BlueIO_Setup.vi -> WDSS Data Collection.vi."
In the abo...
High Current Sensor (HCS-BTA)
Specifications and User Guide
Troubleshooting
Primary Test: Plug the probe into an interface and run the data collection program. Use wire leads to connect the probe to a DC supply with a known ...
The 30-Volt Voltage Probe (30V-BTA) probe was designed to monitor alternative energy sources like large solar panels or wind turbines. The unit has a 30K ohm input impedance. This is low enough compared to the the usual input impedance of multimeters...