If your Colorimeter does not have a CAL button, use the instructions in the document below to calibrate your Colorimeter.
http://www2.vernier.com/til/1665/colorimeter_calibration.pdf
If you are using EasyData for data collection, Vernier can provid...
Yes. Traditionally, a solution of sodium sulfite is used as the zero-oxygen calibration solution but this is NOT recommended for the Optical DO Probe. A zero-oxygen calibration solution can be created by bubbling nitrogen gas into distilled water.
...
Calibrating the Goniometer (GNM-BTA) may not be necessary for some activities. If you are evaluating the range of motion of a joint, such as the knee or elbow, then the stored calibration should work well. For dynamic analysis of a joint you may want...
If a pH probe is drifting or not holding a calibration immediately after the calibration process is performed with freshly prepared, accurate standards, then there may be a few things wrong with it.
First, consider the age of the pH Sensor. How o...
If the gel (liquid) inside the body of the electrode is "low" (i.e., less than half the length of the body of the electrode), the sensor may still work properly. However, it may need to be calibrated each time before use (How do I calibrate a sensor ...
This information pertains to the original LabQuest.
If you have LabQuest 2, see this article.
If you have a LabQuest 3, see this article.
If the screen is not responding, try pressing the Home hardkey on the face of the unit. If the menu comes ...
Yes - with limitations. Vernier spectrometers can be used to explore blackbody radiation qualitatively, such as observing general trends in emission spectra. However, they are not calibrated for absolute intensity, so accurate quantitative compariso...
In most cases, the Stainless Steel Temperature Probe will never need to be calibrated. It is calibrated extremely well before it ships. However, if the need arises to calibrate the sensor, and you are using Logger Pro 3.3 or newer, the sensor can be ...
Logger Pro makes default calibrations available for all common units for supported sensors. Most Vernier sensors are auto-ID sensors. Auto-ID sensors can be either Smart sensors or Resistor-ID sensors. Smart sensors contain a memory chip that stores...
It is almost never necessary for someone using a Go!Temp to calibrate it. Each device is carefully calibrated as part of the manufacturing process, and they are very accurate and repeatable. If you really want to calibrate, you can. There are two p...