When using the LabQuest Viewer with a LabQuest and Go Direct sensors, you may find that the list of discovered Go Direct sensors will not show up on the LabQuest Viewer's display. This is because there is bandwidth competition between the Bluetooth...
Since network connections can temporarily drop due to network interruptions, the networking stack holds onto the old IP addresses of LabQuest devices for a period of time, even if LabQuest is turned off or the connection is intentionally disconnected...
It is possible that the software on the LabQuest that supports the LabQuest Viewer functionality can get into a bad state. To recover from this issue, reset the LabQuest software by doing the following:
LabQuest 2 or LabQuest 3
1. Launch the Connect...
You can use the Modify option of the LabQuest Viewer Windows installer to reinstall the Bonjour software. When selecting to Modify the install, do the following:
1. Select the Bonjour version appropriate for your system: 32-bit or 64-bit
2. Selec...
LabQuest Viewer 2.0 software requires Windows 7 Service Pack 1. Update your Windows 7 software to SP1 or newer in order to use LabQuest Viewer.
Related Topics
Why does LabQuest Viewer 2.0 prompt me about Microsoft .NET Framework on my Windows 7 ...
This capability is part of LabQuest Viewer 2.0 functionality.
What are the system requirements for LabQuest Viewer?
If your computer system is unable to run version 2.0, try the following:
Windows
&nbs...
- LabQuest Viewer version 2.0 is compatible with OS X 10.9 Mavericks and OS X 10.10 Yosemite.
- LabQuest Viewer version 1.0 is not supported.
Related Information:
What are the system requirements for LabQuest Viewer?
Is your software compatibl...
LabQuest Emulator
LabQuest Viewer
Cost for software
No Longer Available
LabQuest Viewer® (LQ-VIEW)
Available for Windows
Yes (XP [32 bit only], Vista, 7)
Yes (v:1.1: XP, Vista, 7; v:2.0: 7 SP1, 8, 8.1, 10)
Available for Mac
No
Yes (v:1....
The following are the system requirements for:
- LabQuest Viewer® (LQ-VIEW)
- LabQuest Viewer® (LQ-VIEW-E)
Version 2.0
Mac System Requirements
- OS X 10.8 and newer
- Requires approximately 5.0 MB disk storage; you should have at least 10 MB...
The Viewer 1.1 software requires Windows Vista Service Pack 2. Update your Vista software to SP2 or newer in order to use LabQuest Viewer....