Hand-Grip Heart Rate Monitor (HGH-BTA)
Specifications and User Guide
Troubleshooting
Primary Test: Snap the module into place on the hand grips. Connect the receiver to an interface and start the data collection software. Hav...
Blood Pressure Sensor (BPS-BTA)
Specifications and User Guide
Troubleshooting
The Blood Pressure Sensor will not report blood pressure parameters unless data collection has started.
The data-collection software needs...
Pyranometer (PYR-BTA)
Specifications and User Guide
Troubleshooting
Primary Test: Make sure that the sensor detects sunlight. A bright sunny day should approach a thousand Watts/square meter in irradiance.
Secondary Test: ...
Logger Lite is no longer updated and is likely to be incompatible with newer computers.Use Vernier Graphical Analysis App instead.
Product Overview
What is the difference between Logger Lite and Graphical Analysis App?
What are the dif...
Vernier Circuit Board (VCB, discontinued)
Specifications and User Guide
TROUBLESHOOTING
- Primary Test: Check for physical defects. Check for proper power supply. There is also a resettable fuse located to the right of switch SW1. This fuse li...
Low-g Accelerometer (LGA-BTA)
Specifications and User Guide
Troubleshooting
Primary Test: Point the sensor arrow upward and hold sensor motionless; reading should be approximately 9.8 m/s². Point arrow downward; reading sho...
Soil Moisture Sensor (SMS-BTA)
Specifications and User Guide
Troubleshooting
Primary Test: In air, the Soil Moisture Sensor should read somewhere between -5% and -50%. Grab the sensing portion with your hand, and the read...
Instrumentation Amplifier (INA-BTA)
Specifications and User Guide
Troubleshooting
Primary Test: Confirm that the range setting on the sensor is appropriate for the device connected to the Instrumentation Amplifier.
Se...
25-g Accelerometer (ACC-BTA)
Specifications and User Guide
Troubleshooting
Primary Test: Make sure that the line marked by the arrow on the label of the sensor is positioned properly to measure the desired acceleration.
S...
Stir Station (STIR)
Specifications and User Guide
TROUBLESHOOTING
-Primary Test (using C batteries): Place a 250 mL beaker, with about 100 mL of water, on the platform of the Stir Station. Place a magnetic stirring bar in the beaker of water and tur...