Go!Temp (GO-TEMP)
Troubleshooting
- Primary Test: Plug in the sensor and run the data-collection program. Hold the tip of the sensor in your hand and check for the temperature readings to change.
- Secondary Test: Verify the LED on Go!Temp is green. If your LED is not green, see:Â The LED on my Go! device or LabQuest Mini is not green. What does that mean?
Additional Troubleshooting
- Do Go! devices work with the LabQuest App?
- Why is Logger Pro not connecting to the interface and reading "No Device Connected" in the toolbar?
- Go!Temp used to work, but now is not recognized by computer.
- Logger Lite does not detect any sensors.
- How do you calibrate a Go!Temp in Logger Pro?
- When collecting data on LabQuest at very slow data rates from Go! Devices, data collection ends before it should.
Specifications
- Range: –20°C to 115°C
- Maximum temperature that the sensor can tolerate without damage: 150°C
- Resolution: 0.07°C
- Accuracy: ± 0.5°C
- Response Time: 4s (to 90% of full reading in water)
Calibration
Calibrate? No. Go!Temp is very nicely calibrated when shipped. Most never need to calibrate. However, if you need to, you can do a one-point or two-point calibration. For more information on sensor calibration, see How do I calibrate my sensor?
Related Products
- Stainless Steel Temperature Probe (TMP-BTA)
- EasyTemp (EZ-TMP)
- Extra-Long Temperature Probe (TPL-BTA)
- Surface Temperature Sensor (STS-BTA)
- Wide-Range Temperature Probe (WRT-BTA)
- Thermocouple (TCA-BTA)
- Go Direct® Temperature Probe (GDX-TMP)