Go Direct® Emissions Spectrometer (GDX-SPEC-EM)
Specifications and User Guide
Vernier Emissions Spectrometer (VSP-EM)
Specifications and User Guide
TROUBLESHOOTING
- Primary Test: When you connect the Emissions Spectrometer to a device running Spe...
You likely are not producing enough voltage with your turbine design. The color of an LED determines the minimum voltage needed for it to emit light. This has to do with the colors of light having different amounts of energy. A colored LED is not a w...
We have worked closely with Independence Science and its President Cary Supalo to ensure that Logger Pro works well using Screen Readers like JAWS. In addition to Jaws with Logger Pro, you will also need the Jaws Scripts to allow full access and uti...
The sample PDFs on our website were vey popular. They also caused a lot of confusion. For example, the PDFs are not editable, do not include the teacher notes (or answer key), and only show one version of the lab. We create instructions for each expe...
This issue occurs when using a Motion Encoder Cart Receiver (MEC-BTD), with a LabPro Interface. The zero point is not maintained between experimental runs.
This is caused by an interaction between the encoder system and LabPro.
This behavior cannot...
If the number of decimal places displayed in the software does not match the display on the balance, you can change them by doing the following:
1. LabQuest App: Tap the Table tab. Choose Data Column Options▶Mass from the Table menu. Change...
The Force Plate, like any sensor, has a limit to how quickly it can respond to a change. If a very short impulse is applied to the force plate, it will vibrate, or ring, for a short while. That ringing can interfere with your measurement.
Revis...
Magnetic Field Sensor (MG-BTA)
Specifications and User Guide
Troubleshooting
Primary Test: Confirm that the setting switch on the sensor wand is appropriate for the experiment. The low amplification (6.4 mT range) is used...
Yes, O2 gas concentration can be expressed in units of mg/m³. However, the value is dependent upon temperature and pressure.
At Standard Ambient Temperature and Pressure (SATP), 25°C and 100 kPa, the conversion is:
1% O2 = 12,912 mg/m³
Logger P...
Yes, CO2 gas concentration can be expressed in units of mg/m³. However, the value is dependent upon temperature and pressure.
At Standard Ambient Temperature and Pressure (SATP) of 25°C and 100 kPa, the conversion is:
1 ppm CO2 = 1.7758 mg/m³
L...