The control knob on the Melt Station is held in place with two set screws. The drive size of the set screws is 1.5 mm. Vernier does not supply or sell a wrench for the set screws. However, you can purchase an inexpensive 1.5 mm hex wrench at any most...
No. Logger Pro for Linux is no longer available for download. If you already have a copy of the software, you can continue to use it; however, no new downloads or updates are available.See: Linux support for Graphical Analysis Progressive Web App
...
There are two different radiation cables in circulation due to differences in radiation monitor design. They are not interchangeable, so only use the cable that came with your particular radiation monitor.
The cables can be distinguished easily, as ...
If you are using the Motion Encoder Cart (DTS-CART-MEC) on a long 2.2 m track, you will need to adjust the emitter to the 2 m setting. The switch is located directly under the tab used to open the battery compartment.
The IR transmitter on the...
Make sure you are using a version of the software that was released after the Encoder system was invented.
For Logger Pro, version 3.8.6.2 or newer is needed.
For Original LabQuest, version 1.7.2 or newer.
For LabQuest 2, version 2.3.3 or newer.
For...
Video Physics has several privacy controls which can be accessed in Settings. Allowing permission for each of these settings enables Video Physics to do the following:
Photos: Video Physics uses the Photo Library (Camera Roll) to save a copy of an...
Sometimes our computers don't make the right file-type associations. Rather than double-clicking the file you want to open and having it tell you it can't be opened by Word or can't find Word, try launching Word first and opening the file from within...
Yes, salinity correction factors can be calculated by using the USGS DOTABLES program at http://water.usgs.gov/software/DOTABLES/
Refer to part C.
If the Optical DO Probe or Dissolved Oxygen Probe has been calibrated for fresh water then any m...
LabQuest 2.3.3
• Fixes a 2.3.1 issue with negative temperature readings when using Go Wireless Temp.
LabQuest 2.3.1
New Sensor Support
• Go Wireless Temp (for LabQuest model LQ2-LE only - How do I know if my La...
The free update and instructions for installing LabQuest software updates are available on our web site on the pages listed below.
Original LabQuest
https://www.vernier.com/downloads/original-labquest-updates/
LabQuest 2
https://www.vernier.com/dow...