The Power Amplifier can amplify any signal sent to it up to 15 kHz. LabPro has a built-in function generator, which goes up to 166 Hz.
If you need higher frequencies, there are several options:
- Use our free Power Amplifier Function Generator ...
There is a known limitation of the LabPro interface such that data from the photogate will not display until the experiment ends. As a result, you must not click stop before data collection ends on its own.
If you click Stop during data collection, ...
For most TI calculators the answer is yes. Note: The Function generator is not supported by TI-NSpire technology.
In addition to the sensor, you will need
LabPro interface Voltage Probe (VP-BTA) - one was included with LabProSoftware appropr...
This process will load the 6.27 version of the LabPro operating system onto your interface. It will also load the most recent DataMate programs.
What you need
TI Connect software
TI Connectivity cable
AC adapter or fresh AA batteries...
There are four possible explanations:
It was manufactured before 2008, which is when it became auto-id.
If you are trying to use a Drop Counter with a LabPro, the Drop Counter will not auto-id. This is because the firmware in the LabPro pre-dates th...
The Power Amplifier has two control inputs:
-The BTA input is used for CH4 from LabPro
-The mini-audio input is used for LabQuest.
The LabQuest input overrides the LabPro input, so that if the audio cable is left connected to the Power Amplifier, th...
After upgrading the LabPro with Logger Pro 3.1 or 3.2, if you start the DataMate application and do not use the [CLEAR] button on the Main Screen to refresh the setup, your motion detector may not collect good data. The motion detector will appear t...
LabPro battery life depends on the number and type of sensor being used as well as how frequently data are being collected. Below you will find a chart that summarizes battery life under a variety of conditions.
Sensor UsedLow-cost 6V BatteriesDur...
LabPro is powered either from batteries or from an AC mains adapter. LabPro requires a regulated 6VDC power source capable of supplying 600mA.
We have an international power supply available: PSLP-INT...
The Vernier-branded Rotary Motion Sensor (RMV-BTD) can not ID on in Logger Pro when used with a LabPro interface because the LabPro firmware was created before this sensor. There is no plan to update the LabPro firmware.
There are workarounds:
1. Ma...