There are at least two possible causes for the force sensor to read a high constant value. It has been stressed beyond its capacity and......
The short answer is yes. A little construction is required to create a platform to connect the Test Wall to the Vernier Structures and Materials......
Specifications and User Guide Troubleshooting – Primary Test: Â Press the power button on the sensor to turn it on. (The red LED should flash.) Start......
The VSMT Truss Tester Accessory makes it possible to test single-width trusses on the Go Direct Structures & Materials Tester and the Vernier Structures &......
Specifications and User Guide TROUBLESHOOTING – Primary Test: The VSMT Force sensor will auto-ID with supported releases of software. – Secondary Test: The VSMT Displacement......
Yes. The was specifically designed to be used in bridge-building competitions. It has a 1000-N force sensor/load cell and also measures displacement of the structure.......
Yes. Using the tackle provided with the Structures & Materials Testers you can apply a load to a beam in a 3-point and 4-point test.......
Yes. The force sensor will auto-ID when using Logger Lite. If you are using only the force sensor, you are ready to go after starting......
Yes, the force sensor on the VSMT will auto-ID with SensorDAQ and LabVIEW. The displacement sensor will work with some creativity: 1. In LabVIEW, choose......
The force sensor portion of the may be loose in some units shipped in April 2015. Tighten the VSMT force sensor (also known as the......