...ethanol sensors? Is there a way to calibrate the Motion Detector? Can I perform a two-point calibration for the Optical DO Probe? Can I perform a custom calibration of a......
...The website for this product can be found at: https://www.a-msystems.com/p-521-reusable-mouthpieces.aspx These mouthpieces work well on both of our spirometers. These are the Go Direct® Spirometer (GDX-SPR) and the Spirometer (SPR-BTA)......
Support for Vernier Analog (BTA) and Digital (BTD) Sensors The LabQuest emulator runs LabQuest software version 1.5 and supports many of the same sensors as the LabQuest App. Sensors supported......
...computer use the audio cable, LabPro uses a BTA cable from CH4 to the Power Amplifier). Check that the Power Amplifier is plugged into AC power and is turned on.......
...cases such as the Dual-Range Force Sensor (DFS-BTA) and Wireless Dynamics Sensor System (WDSS), different methods are used to attach the sensor to the cart. DTS carts are easier to......
If you calibrate a PH-BNC electrode with an Electrode Amplifier (EA-BTA), typical potential readings are -pH 4 buffer solution: 1.56 volts -pH 7 buffer solution: 1.17 volts -pH 10 buffer......
...100,000 samples/s (USB) 10,000 samples/s (wireless) 100,000 samples/s Built-in color screen Yes No No Available sensor ports LabQuest 2 LabQuest 3 LabQuest Stream LabQuest Mini BTA – Analog Port 3......
...(-DIN and -BTA, pre-2007) Calibration ‘CO2 ppm’: Equation: Linear y = bx + a a: b: 2000 Calibration ‘CO2 ppt’: Equation: Linear y = bx + a a: b: 2......
...(BTA-ELV) connector, a breadboard, and referencing our sensor pinouts guide. The output from our sensors with the Hummingbird is in the form of a voltage which must be converted to......
...(BTA-ELV) and a breadboard, using https://www.vernier.com/support/sensor-pinouts/ as a guide for connecting our sensors. You can connect a Go!Temp or Go!Motion sensor directly to your computer that you are using to......