...also need a BTA-ELV adapter, a BB-BTA, a breadboard, and some jumper wires. The BTA-ELV is an adapter that will accept the BTA connector from the CO2 sensor. Connect the......
Tech Support Search
...input line. Those sensors are the simple voltage probe (VP-BTA) and 30V-BTA. Ion Selective Electrodes (NH2-BTA, CA-BTA, CL-BTA, NO3-BTA), the Wide-Range Temperature Probe (WRT-BTA), Tris-compatible pH Electrode (FPH-BTA), and the......
...Probe (TPL-BTA) –Wide-Range Temperature Probe (WRT-BTA), (for use with temperature range of –20 to 330 deg C (–4 to 626 deg F) –Thermocouple (TCA-BTA), (for use with super-cooled liquids and......
...but does not adjust the calibration gain. RELATED VERNIER PRODUCTS Voltage Probe (VP-BTA) 30-Volt Voltage Probe (30V-BTA) Instrumentation Amplifier (INA-BTA) Go Direct® Voltage Probe (GDX-VOLT) Vernier Circuit Board 2 (VCB2)......
...Slope: 514.839 Thermocouple degC High Intercept: -284.075 Slope: 353.501 RELATED VERNIER PRODUCTS –Stainless Steel Temperature Probe (TMP-BTA) –Extra-Long Temperature Probe (TPL-BTA) –Wide-Range Temperature Probe (WRT-BTA), (for use with temperature range......
Our LabQuest sensors all use BTA/BTD (British Telecom Analog/Digital) cables to connect to a Vernier interface. BTA/BTD connectors have 6 pins and therefore BTA/BTD cables contain 6 wires. If you......
Note that the Current & Voltage Probe System (NO LONGER AVAILABLE) (CV-BTA, discontinued) is no longer available, and has been replaced by the combination of: Current Probe (DCP-BTA) and Differential......
...sensor? What is the difference between a Differential Voltage Probe (DVP-BTA) or Go Direct Voltage Probe (GDX-VOLT) and the simple Voltage Probe (VP-BTA)? What is the input impedance of a......
...Oxygen Gas Sensor (O2-BTA) do I have? The Vernier O2 Gas Sensor contains an electrochemical cell that has an average lifespan of about six years when stored properly (upright). When......
...whether you are using the Power Amplifier and VP-BTA connected to a LabQuest (via the audio cable) or connected to a LabPro (via the double BTA cable). This would be......