Vernier BTA and BTD sensors all work based on 5-volts.  For more information on that go to https://www.vernier.com/engineering/arduino/ Most Arduino models work based on 5-volts.  A few, mostly newer, Arduino models are based on 3.3 volts. ...

Go Direct® Voltage Probe (GDX-VOLT) Specifications and User Guide Troubleshooting General: Press the power button on the sensor to turn it on. Connect your sensor as described in the Getting Started instructions for your d...

Use our sensor pinout information when building your own sensors to work with our interfaces or when you want to use our sensors with your own A to D converters. British Telecom Analog (Right Hand) Pinout Pin 1 = ±10 Volt - ...

Power Amplifier (PAMP) Specifications and User Guide Troubleshooting Primary Test: Check the connections. Does the yellow LED turn on when you flip the front switch on (up, toward the "1")? If you are controllin...

Both sensors both use a MEMs-based microphone and are very similar in their response to sound. The major benefit of the Microphone (MCA-BTA), is the flexibility of the "wand" style form factor for positioning the sensor in an experiment. The MCA-BT...

Vernier lab books contain dozens of labs that meet the IB Chemistry standards: IB Chemistry standards correlated to Vernier lab activities. The equipment listed below is based on the contents of our Advanced Chemistry lab book. IB Teachers also find...

Most Vernier sensors are not meant to be completely submerged in water. In general, sensors that measure some parameter of water, e.g., pH, conductivity, or dissolved oxygen, should only be inserted a few centimeters, or as directed in their user man...

This sensor is no longer available. Information is presented for reference only. TI Light Sensor (TILT-BTA, discontinued) Below is the information that was included with the sensor when purchased from Vernier. The sensor was also include...

Go Direct® Pyranometer (GDX-PYR) Specifications and User Guide Troubleshooting General: Press the power button on the sensor to turn it on. Connect your sensor as described in the Getting Started instructions for your device...

For each lab station, you need to order ONE each of the following: Dynamics Cart and Track System (DTS) Fan Cart (CART-F) Motion Detector (MD-BTD) Heat Pulser for LabPro (HP-BTD, discontinued) (also works with LabQuest interfaces - all model...