The Vernier Circuit Board 2 (VCB2) includes all of the components that are included on the Vernier Circuit Board (VCB, discontinued) with the same pin numbers, with the following additions:
47 kΩ resistor
1 uF capacitor
5 mH inductor with powdered ...
Tech Support Search
Vernier Circuit Board 2 (VCB2)
Specifications and User Guide
This article is about the Vernier Circuit Board 2, introduced in late 2015. Information about the original Vernier Circuit Board can be found at Vernier Circuit Board (original model) Trou...
Vernier Circuit Board (VCB, discontinued)
Specifications and User Guide
TROUBLESHOOTING
- Primary Test: Check for physical defects. Check for proper power supply. There is also a resettable fuse located to the right of switch SW1. This fuse li...
There are two different lamps provided with our Vernier Circuit Board 2 (VCB2). The Vernier Circuit Board 2 comes with 5 cylindrical bulbs (#48), 2.0 V, 60 mA. It also comes with 5 round bulbs, (#50), 7.5 V, 220 mA.
These two types of light bulbs a...
Yes, resonance in RLC circuits can be investigated with either the Vernier Circuit Board (discontinued)or the Vernier Circuit Board 2 (VCB2).
If using the Vernier Circuit Board, an inductor such as Inductor (IND) will be needed. However, the Verni...
This article refers toVernier Radiation Monitor (VRM-BTD)Go Direct® Radiation Monitor (GDX-RAD)
The dead time, tdead, is the duration of time, beginning at the start of a detection event, during which a detection system is incapable...
Follow these instructions to remove or replace a Go Wireless® 100 mAh Replacement Battery (GW-BAT-100), in your Go Wireless pH or Go Wireless Electrode Amplifier. Follow these instructions carefully as PERMANENT DAMAGE can result if not done pro...
In April of 2018, it was determined that switches SW1 and SW4 pose a safety hazard.
Affected products: All Vernier Circuit Board 2 (VCB2), shipped prior to April 11, 2018 with the mark VCB2 REV 1 PPRL 2015and the mark...
Follow these instructions to remove or replace a Go Wireless® 250 mAh Replacement Battery (GW-BAT-250), in your Go Wireless Link. Follow these instructions carefully as PERMANENT DAMAGE can result if not done properly.
To replace batteries on...