The current and voltage probes for the CV-BTA system are different from the ones for the CV-DIN system. The former are marked with blue bands on the cables. If you use the probes from a CV-DIN on a CV-BTA, the probes won't autoID properly. Solution: ...
Tech Support Search
The Force Plate, like any sensor, has a limit to how quickly it can respond to a change. If a very short impulse is applied to the force plate, it will vibrate, or ring, for a short while. That ringing can interfere with your measurement.
Revis...
Due to the simple nature of the sensor, the ±10 V Voltage Probe (VP-BTA) may not read 0 V when the leads of the sensor are not connected to anything. While not desirable, this is expected behavior for this sensor. The value you get depends on which...
It is always a bit tricky to state an accuracy figure, since it depends on what the sensor is connected to and how it has been calibrated.
Assuming you are using DVP-BTA connected to a LabPro or LabQuest, the first number to look at is resolution,...
This article refers to the original version of the Force Plate (FP-BTA) (those purchased prior to November 10, 2023). Refer to the video below to determine if this is relevant to your force plate. You should, in all cases, contact Technical Support ...
Go Direct® O2 Gas Sensor (GDX-O2)—current version
We currently sell the Go Direct Oxygen Gas sensor, which was first sold in 2018.
This sensor can connect via USB or Bluetooth. No interface is required.
This version of the Ox...
Breadboard Cable (Analog) (BB-BTA)
Breadboard Cable (Digital) (BB-BTD)
TROUBLESHOOTING
The Vernier Breadboard Cables are fairly simple. One end of the cable is either a British Telecom Analog (BTA) plug or a British Telecom Digital (BTD) plug that c...
This is associated with the original version of Force Plate (FP-BTA) shipped before November 10, 2023. (Units newer than that ship with a 2-meter removable "BTA to BTA" cable. Contact Technical Support if you require assistance with this cable.)
...
The default data-collection range for the Thermocouple (TCA-BTA) is set to have the best accuracy between 0°C and 900°C. There are two other settings available for data collection if you would like increased accuracy at a lower temperature or a hig...
Current Probe (DCP-BTA)
Specifications and User Guide
Troubleshooting
Primary Test: Plug the probe into an interface and run the data collection program. Use wire leads to connect the probe to a DC supply in series with a know...